Érintett modell

Ez az információ a következő típusokra vonatkozik:

  • PMW-200

NEW FEATURES & IMPROVEMENTS:
 
1.) i.LINK DVCAM Input
Stream signal recording via i.LINK DVCAM input is available.
2.) Adjusting the Brightness of the EVF Screen
The default value of EVF has changed from ±0 to +30.
3.) Selecting AUDIO IN Reference Input Level
The default value of Audio Input has changed from -40 dB to -60 dB.
4.) External Device Connector
A message will be displayed if a USB device which is not supported by this unit has been connected.
5.) Auto Focus
Auto focus performance is improved. Focus instability near the focal point and with a high-luminance background has been reduced.
6.) Auto Knee
Auto Knee performance is improved. Emphasis of white for an object with a high-luminance background has been reduced.
7.) ATW
ATW performance is improved. When ATW mode is set to Natural, automatic adjustment for wider brightness range when shooting outdoors is available.
8.) Matrix Adjustment
Can be put on OFF in PICTURE PROFILE SET.
 

NOTE:
If ‘Version Upgrade Error!!’ is displayed during the installation, it usually means a data communication error has occurred.
1.) Power OFF and ON once.
2.) The unit will initially appear to be unresponsive whilst the recovery process is running. Wait at least 2 minutes to allow the unit to recover.
3.) Follow the on-screen instructions.
If the unit does not recover after 2 minutes, restart the upgrade procedure as described in VerUpOM(E).pdf. 
 
IMPORTANT INFORMATION:
Auto flange back adjustment must be performed after installing this software. Refer to Auto Flange Back Adjustment Guide + Chart
for details.